Deck o Seal Alternative NovaLink SL Swimming Pool Deck Self-Leveling Elastomeric Sealant Stone Tan 68oz. F1239ST by ChemLink – 4 Pack
NovaLink SL Swimming Pool Deck Self-Leveling Elastomeric Sealant ‘s Technical Data Sheet
NovaLink SL Pool Deck Joint Sealant is a self leveling, moisture curing sealant, designed for application on horizontal joints in concrete construction such as driveways, sidewalks, balconies, stairwells and surrounding fountains and swimming pools.
NovaLink SL Pool Deck Joint Sealant cures rapidly to a solid rubber seal that can accommodate 25% joint movement. Its unique polyether cure chemistry allows
NovaLink SL Pool Deck Joint Sealant to be installed on damp concrete or in damp weather conditions without “outgassing” or forming CO2 bubbles, as urethane sealants often do. Its excellent self leveling properties and smooth finish allow NovaLink SL Pool Deck Joint Sealant to be installed without tooling. The elimination of masking tape and tooling results in a significant reduction in labor. NovaLink SL Pool Deck Joint Sealant is solvent free and will not shrink. Its excellent adhesion to clean masonry or concrete allows it to be installed without a primer in most joints smaller than 1/2 inch wide.
Applicable Performance Standards
• ASTM C920, Type S, Grade P, Class 25, Uses T2, M,& O
• Federal Specification TT-S-00230-C Type I, Class B
• Corps of Engineers CRD-C-541, Type I, Class B
• Canadian Standards Board CAN 19, 13-M82
Regulatory Compliance
• Conforms to OTC Rule for Sealants
• Meets requirements of California Regs: CARB and SCAQMD
• This product does not contain cancer causing chemicals listed in California Proposition 65.
• Conforms to USDA Requirements for Non-food Contact
Advantages
• Solvent free, 100% solids will not shrink
• 30 minute skin over
• No outgassing on damp surfaces
• Color stability, will not suntan
• Paintable within 24 hours (See limitations)
• +/- 25% joint movement
Joint Preparation
Joint surfaces should be clean, dry and free from all contamination including: dirt, oils, grease, tar, wax, rust and any other substance that may inhibit the sealant’s performance.
Joint Design
Install all joint applications per ASTM and SWRI recommendations and guidelines. Joints shall be designed with a depth to width ratio of 1:2 (joint depth one-half the width). Control the depth of the sealant by using a polyethylene backer rod that is 25% larger than the joint opening at standard temperature. To prevent three-point adhesion use a backer rod or bond breaker tape to ensure proper joint movement and a long lasting weatherproof seal. Where the joint configuration will not permit a backer rod, CHEM LINK recommends that an alternative bond breaker be used.
NovaLink SL Swimming Pool Deck Self-Leveling Elastomeric Sealant Coverage
Reviews
There are no reviews yet.